Gray Water Tank Waste Valve With A 48" Cable Actuator

Question

Question:

Is this part available with a 48inch cable? I have a 2007 Winnebago Outlook and am having trouble opening and closing the gray water valve. Have already replaced the seals. Please advise.

asked by: Dennis Z

0

Expert Reply:

There is currently only a 72" cable # TC72PB available to go with the Valterra Waste Valve for RV Gray Water Tank # T1001PBC. If you want a gray water waste valve with a 48" cable you would need the LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank # 34466N11AB48GMA.

expert reply by: Kevin C

0

Answer 1

From what I could find on the Dexter 072-042-00 leaf spring, it appears to be the standard 1-3/4 inch wide double eye spring which is 25-1/4 inches long and rated up to 1,750 pounds (per spring). With that said, the 4-Leaf Double-Eye Spring for…

view full answer...

Answer 2

We do have a bearing kit that includes the correct bearings and races for the Dexter 031-030-02 and 031-032-02 bearings, as well as the 010-036-00 grease seal. The correct kit is the following: - Bearing Kit #BK3-300

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Gray Water Tank Waste Valve With A 48" Cable Actuator

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching