Could MORryde Sliding Tray for RV Cargo Compartment # MR65FR Fit in Bed of 2020 Ram 3500
Updated 08/02/2021 | Published 08/01/2021
Question:
Will the 36inch x 48 inch cargo tray fit in the rear part of my long bed Ram 3500 between the tail gate and an Andersen hitch?
asked by: Todd H
0
Expert Reply:
It's possible but you'd have to measure the available area you have in your truck bed to see if the MORryde Sliding Tray for RV Cargo Compartment # MR65FR could fit. You'd need to have 36 inches between the end of the truck bed and the rear of the Andersen hitch that you have. If that check out this would fit.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
MORryde RV Cargo Slide Tray - 36" x 48" - 1 Way Slide - 60 Percent Extension - 800 lbs
- RV Cargo Slides
- Cargo
- Carpeted Floor
- 60 Percent Extension
- 48 Inch Wide
- 1 Way
- 36 Inch Long
- 800 lbs
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will Upgrading My Trailer Hitch Increase The Towing Capacity Of My 2024 Ford F-250?
- Q&A: Curt TriFlex NEXT Brake Controller and Install Harness for 2022 E-Series Cutaway
- Q&A: How Much Floor Clearance Is There With the Kwikee Heavy Duty Tray Assembly Kit LC370794
- Q&A: How Would the SnapPad Base Install Onto Andersen Jack Blocks?
- Q&A: Recommended Slide Out Tray for a Predator 5000 Inverter
- Q&A: Best Slide-Out Tray Options for Camper Van Storage 32" Deep x 48" Wide
- Q&A: Can The MORryde Sliding RV Cargo Tray Accommodate A Bicycle Fork Adapter
- Article: Trailer Wiring Diagrams
- Article: The Best Electric Trailer Jacks of 2025
- Article: Best Bike Racks for Electric Bikes
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)