Where Does the Black Connector On the Curt Vehicle Wiring Harness for a 1996 Jeep Grand Cherokee Go
Updated 07/19/2021 | Published 07/18/2021
Question:
where does the yellow and black harness plug into
asked by: Joe
0
Expert Reply:
In regards to the Curt T-Connector Vehicle Wiring Harness part # C55260 which is a fit for a 1996 Jeep Grand Cherokee, the black connector will be hooked-up to the right hand taillight and the gray connector will be hooked-up to the left hand taillight.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- Factory Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Wiring Recommendation for a 1996 Jeep Grand Cherokee Limited
- Q&A: Average Expected Installation Time For A Demco Air Force One Flat Tow Brake System
- Q&A: Replacement RF Controller for Blue Ox Patriot II or Patriot 3 Flat Tow Brake System
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Parts Needed to Flat Tow a 1989 Jeep Cherokee Behind a Motor Home
- Q&A: Black and Red Wire Connection on Trailer Tail Lights
- Q&A: Factory Connector Location to Install Trailer Wiring on 1997 Jeep Grand Cherokee w/Tow Package
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)