What Wire Colors are Needed to Install a Pop and Lock Tail Gate Lock on a 2013 Ford F-150 Super Crew
Updated 04/17/2013 | Published 04/14/2013
Products Featured in This Question
Question:
I have a 2013 Ford F150 Super Crew Lariat. Im installing this lock, and wonder if you can confirm for me the correct colored wires I should find under the rear drivers side sill plate, I would very much appreciate it.
asked by: Neal H
Expert Reply:
On a 2010 and up Ford F-150 the wires should be light blue with a green stripe and gray with a brown stripe. However, the manufacturer could use any color wire they need to if they happened to run out of one color on the assembly line. The best way to find the correct wires is to test them with a circuit tester like # PTW2979 if needed.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Looking For Electric Brakes And Hub/Drums For Lippert 3,500 lb Axle
- Q&A: What are the Correct Bearings, Races, and Seals for 4,400 Pound Axle?
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Replacement Brake Shoes For Al-KO 10" X 2-1/4" Electric Brake Drums On a 2002 Forest River Flagstaff
- Q&A: Which Timken Grease Seal for Trailer Hub Replaces GS-1719 DL
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices