Mounting Bolt Dimensions of Demco Actuator DM72VR
Updated 06/08/2021 | Published 06/07/2021
Question:
What is the bolt spacing that connects the actuator to the tongue
asked by: John R
0
Expert Reply:
On the Demco Actuator # DM72VR the upper holes are separated by 3 inches and vertically they are 2 inches apart.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 7000 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Demco
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement Actuator for an Older Atwood 85736
- Q&A: Surge Brakes for Demco KK260 Tow Dolly
- Q&A: Is There Manual Lockout Available for Demco Surge Actuator part # DM72VR
- Q&A: New Brake Assemblies, Hub/Drums, Brake Lines, and Bearing Buddy for Trailer with 3,500 lb Axle
- Q&A: Replacement 10" Drum Hydraulic Trailer Brakes for Converting 3,500 lbs Axles to Hydraulic Brakes
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: Most Popular Wheel Bearings
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide