Does 2013 Toyota Sienna with Timbrens Need Weight Distribution Hitch
Updated 05/26/2021 | Published 05/24/2021 >
Question:
Towing with a 2013 Toyota Sienna. 3500 lbs. towing capacity. Transmission cooler and Timbren Stops installed. Purchased a 1700 lbs. Flagstaff MAC pop up 250 lbs. tongue weight. Should I be concerned with rear sag? Dealer says a weight distribution hitch would bend the pop up frame. Is this true? If not what do you suggest? Or am I worrying too much and just enjoy it?
asked by: Robert A
Expert Reply:
With the Timbrens # TTORSEN04 installed on your 2013 Toyota Sienna I wouldn't worry about weight distribution for a tongue weight of only 250 lbs. If the dealer says your pop up shouldn't be used with a WD system too that's even more reason not to.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Helper Springs for a 2006 Toyota Sienna AWD Model
- Q&A: Recommended Suspension Support for a 2015 Toyota Sienna w/a Sagging Rear End
- Q&A: Does Pacbrake Alpha HD Air Bag Suspension Kit # PB83ZV Come Assembled
- Q&A: What is the Difference Between Curt and Towsmart Hitches for a 2025 Kia Sportage
- Q&A: Transmission Cooler and Suspension Enhancement for a 2011 Toyota Sienna
- Q&A: Troubleshooting Curt 56106 Converter for 2014 Toyota Sienna
- Q&A: Can Thule Revert 4 Bike Rack Fit Hitch with 1 inch Between Pin and Hitch Face
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How to Choose the Right Trailer Hitch Class
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: My Trailer Hitch Doesn't Fit

