Which Ramps Should I Use For My 2015 Polaris Slingshot SL With My Alumina 8218 Tilt Trailer?

Updated 04/02/2021 | Published 03/31/2021

Question:

I have an Aluma 8218 tilt trailer and need to load a 2015 Polaris Slingshot SL. I need 3 racing ramps to load onto the trailer. Which racing ramps do you suggest and can you sell me 3 instead of 2 pair? Need quickly.

asked by: Yopahoda

Expert Reply:

I would recommend a larger lift and as long of a ramp as you can. Since your Polaris Slingshot SL is 150 ish inches long so these ramps # RR-TR-11-2 are your best option! These ramps are 136-7/8 inches long and have the highest lift so you don't have to worry about you bottoming out. It seems like your Aluma 8218 doesn't sit too high so the 11" lift will get you right up there. You can put the ramps under the trailer and tilt it back a little bit since there is a little lip for your trailer to rest on or you can just use the ramps to drive onto the level trailer. I've done both!

Unfortunately, these only come in a pair of two. Personally, I would have two ramps in the middle for the rear tire. Your rear tire is about 9-1/2 inches wide and these ramps are 14 inches wide. That seems like enough but obviously the slingshot isn't your typical vehicle and you wont be able to see the rear wheel that well. If for some reason you roll the back end off one of the sides you would cause some damage. That's why I would use two for the rear tire and get two sets of # RR-TR-11-2.

expert reply by: Adam E