What Gauge Wire is Used in the Hopkins Endurance 4-Way Flat Trailer Wiring Harness, # HM48240
Updated 03/05/2013 | Published 03/03/2013
Question:
What gauge wire is used with the HM48240 4 way flat wiring harness?
asked by: Fred
0
Expert Reply:
I went out to the warehouse and pulled a Hopkins Endurance 4-Way Flat Trailer Wiring Harness, # HM48240. The copper strands inside the wires are 18 gauge. With the jacket on it is between 10 and 12.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Hopkins Endurance 4-Way Flat Trailer Wiring Harness - 20' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 4 Flat
- Plug and Lead
- Hopkins
more information >
Continue Researching
- Q&A: Replacing The Wiring Harness On A Demco Kar Kaddy SS
- Q&A: Replacement 30" Fireplace for 2012 Tiffin Phaeton
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement A/C Shroud for a Dometic Duo-Therm Model 57908.321
- Q&A: Replacement Coupler Parts
- Q&A: Disc Brake Assemblies For Changing A 12,000LB Dexter Axle To Hydraulic Disc Brakes
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Correct Bearing Kit and Brakes for Timbren Axle-Less 3,500 System with 4" Lift
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Basics of Tie Down Straps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations