How to Determine Timbren Helper Spring Fit for 2017 Jeep Wrangler JK With 3 inch Lift

Updated 03/25/2021 | Published 03/23/2021

Question:

I have a 2017 JKU and it has coil overs on it so I cant use airbags that fit inside the springs. I also have a lift of about 3 inches. I was wondering if these will work with a spacer for my jeep? If not can you recommend a helper spring that works on lifted jeeps without coil springs?

asked by: Donnie S

Expert Reply:

Because the # TJRJK is a friction fit into the factory cup where the bump stop fits, a spacer wouldn't work..

If you can provide me a measurement, they might have a fit. They'll need the height difference between the underside of the frame and the top of the rear axle while the vehicle is sitting on the ground. If you can reply with that information, I can check back with Timbren to see if they have a solution for you.

expert reply by: Mike L