Construction of RC Industries Z-Series Underbody Truck Toolbox # UB1416-24
Updated 03/04/2013 | Published 02/28/2013 >
Question:
What is the gauge of the metal used on the box?
asked by: Dave M
0
Expert Reply:
The RC Industries Z-Series Underbody Truck Toolbox you mentioned, part # UB1416-24 is constructed of 14 gauge powder coated steel. The T-Handle is constructed of stainless steel.
expert reply by:
Mike L
0
Product Page this Question was Asked From
RC Manufacturing Z-Series Truck or Trailer Underbody Tool Box - Steel - 3.1 Cu Ft - Glossy Black
- Underbody Tool Box
- Trailer Underbody Box
- Truck Underbody Tool Box
- 14 Inch Tall
- Steel
- Small Capacity
- 16 Inch Wide
- 24 Inch Long
- Black
- RC Manufacturing
more information >
Continue Researching
- Q&A: Recommended RV Vent Cover for MaxxFan 4900k
- Article: Trailer Wiring Diagrams
- Q&A: How do I Change from the Dexter Vault to EZ Lube Hubs on Boat Trailer?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Can I Use Heavier Rated Leaf Springs on Trailer Without Causing Damage
- Q&A: Determining the Correct Leaf Spring Length for Trailer
- Q&A: Wiring Diagram for the Dometic Replacement Single Zone Thermostat
- Q&A: What Axle Seal Does the LC160 Axle 6k Use
- Q&A: Impact of Higher Leaf Count on Double-Eye Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Raise Your Travel Trailer Height
- Article: How to Tell the Weight Rating of a Trailer Axle

