Installation of Curt C56079 Trailer Taillight Wiring Converter on 2010 Toyota Venza

Updated 02/05/2021 | Published 02/03/2021

Products Featured in This Question

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(158)

$56.30

Wire Loom - 1/4" Diameter - 1' Long

(306)

$0.68

Question:

got 90 of my 2010 Venza trailer harness installed. Your on line video was GREAT!. All that I have left is to hook up the wire to the positive post on the battery. Please give the crew that produced the video two thumbs up.

asked by: Randall T

Expert Reply:

Thank you very much! I'll pass that along to our video and install crew.

The best way to make that wiring run from the rear of the vehicle up to the battery would be to locate and follow an existing wiring harness under the vehicle, and zip tie the taillight converter power wire to that every couple of feet. You'll want to be sure to avoid anything moving or hot like suspension or exhaust components.

If you drive on gravel roads quite a bit, you might also consider a length of wire loom like # 7509-1 to protect the wire from road debris that might get kicked up as you drive over it.

expert reply by: Mike L