Replacement Pin For A Frame Jack Foot Plate With 3/8" Diameter Pin Hole
Updated 02/08/2021 | Published 02/03/2021
Products Featured in This Question
Question:
I have a Big Tex 30SA utility trailer and an a-frame top crank jack. The Jack has a foot but Ive lost the pin. I think I remember it being more than a pin but a type that reached around the 2 1/4 of the Jack diameter. It was arc shaped. Any help would be appreciated. The hole through the Jack to hold the foot on is for a 3/8 diameter pin.
asked by: John J
Expert Reply:
The hole through the jack to hold the foot plate on a A Frame Jack isn't specific. You can really put any pin in it as long as it fits the same diameter hole. If you are looking for one that wraps around the jack leg there are a couple different ones to chose from. Item # LC225598, Item # F0938005-40, and Item # 2500-26.
Product Page this Question was Asked From
Replacement 3/8" x 3" Snapper Pin for Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- Lippert
more information >
Continue Researching
- Q&A: Lithium-Compatible Converter for Progressive Dynamics PD4590K18NS2 4500 Series RV Power Center
- Q&A: Replacement Front Jack Tube for a Lippert Ground Control 3.0 System
- Q&A: Replacement Front Jacks for Lippert Ground Control 6 Point
- Q&A: Correct Replacement Legs for Lippert Ground Control 3.0 Leveling System - 6 Point
- Q&A: Is There Rebuild Kit for Replacement Front Jack for Lippert Ground Control 3.0
- Q&A: Grease Maintenance Schedule For Lippert Ground Control 3.0
- Q&A: Dimensions of Weld Tabs and Diameter of Lippert Ground Control Leg # LC362485
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Converting Your RV Water Heater to Tankless