What Is the Mounting Hole Diameter on the CE Smith Front Hanger Bracket # CE14016G
Updated 01/28/2013 | Published 01/25/2013
Question:
What is the hole size for bolting this bracket to the trailer frame?
asked by: Sedgwick S
0
Expert Reply:
The top mounting holes on the CE Smith Front Hanger Bracket # CE14016G are as follows:
The 2 top holes on the ends are 7/16 inches in diameter
The center top hole is 1/2 inch in diameter
The lower spring eye holes are 9/16 inch diameter
I have included a picture showing these measurements for you.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
CE Smith Front Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Snowmobile Trailer
- Slipper Springs - 1-3/4 Inch
- 9/16 Inch Diameter
- 2-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- CE Smith
more information >
Continue Researching
- Q&A: Leaf Spring Replacement for 21-1/2 Spring on 2001 StarCraft Camper
- Q&A: Should Trailer Leaf Springs Have Shackles on Front and Back
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Q&A: Roadmaster Comfort Ride Leaf Spring Suspension Kit for CrossRoads Elevation TF3612
- Q&A: Replacement Axle-Less Trailer Suspension Square Axle 49.5 Hub Face and 38.5 Spring Center
- Q&A: Troubleshooting Slanted Equalizer on Unloaded 7K Cargo Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: Where to Position the Trailer Axle?