Where Do the 2 White Freeze Wires Go When Swapping Coleman for Furrion Chill AC

Question

Question:

I just replaced my Coleman Mach with the Furrion Chill 15,000. What happens to the 2 white Freeze wires that are connected directly to the old Coleman Mach? Thanks

asked by: Robert

0

Expert Reply:

In regards to installing the Furrion Chill Replacement RV Air Conditioner for Coleman Setup part # FR42PV, there should be two white wires on the power unit for the old unit which are labeled as freeze cords. These will go to temperature probes on the new unit which you can see in the attached photo.

expert reply by: Conner L

0

click to enlarge

Mike

6/1/2024

Where does the probe go to on a Coleman camper air

Bud M.

6/1/2024

@Mike I will need to know exactly what model Coleman air conditioner you have to verify the location for the freeze sensor on the AC coil. The model information is going to be located on a tag under the AC shroud on the roof.

Brian A.

7/13/2025

Where does the 2 white wire connect to

Nick S.

7/14/2025

@BrianA In the photo above the 2 white wires go to the temperature probes which are labeled as freeze chords. See the photo above for a better look.

Answer 1

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 2

As long as the weight capacity is inline with your trailer/axle rating and the measurements match your current springs, the number of leaves in a spring pack does not matter. The difference between a 3 and 4 leaf spring pack within the same weight…

view full answer...

Answer 3

Since your 3,500 lb trailer axle leaf springs are flat and measure 26-1/8 inches the correct replacement would be the #e54SR which measures 25-1/8 inches.

view full answer...

Answer 4

What's up, Chuck? You can definitely use higher-rated springs for your trailer, and for that I recommend checking out the 25-1/4" Long 4-Leaf Double-Eye Spring for 4,400-lb Trailer Axles #DX95CR. Be sure to change out the leaf springs on…

view full answer...

Answer 5

A leaf spring should be replaced if it is badly rusted, has cracks or breaks in its leaves or if it is sagging. A 14-year-old travel trailer could certainly be in need of new leaf springs. The keys to selecting correct replacement leaf springs are to…

view full answer...

Answer 6

Hello Mark, thanks for reaching out. When replacing leaf springs, it is important the new springs are identical in length to the old ones. There is a small amount of tolerance, like 1/2" or less, but any more than this can throw the suspension…

view full answer...

Answer 7

I would be happy to help! When measuring for new leaf springs you need to either take them off of the trailer, or jack up the side of the trailer so that the axle is not carrying any weight. Based on the pictures of the leaf springs on your 2017…

view full answer...

Answer 8

The SumoSprings Trailer Helper Springs #TSS-106-40 were intended for use on trailers with weight capacities between 3k and 5k. You are REALLY close to the range of this kit so it would work great still for you since you are 10 lbs under the ideal…

view full answer...

Answer 9

Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…

view full answer...

Answer 10

I spoke with Super Springs about your SumoSprings Trailer Helper Springs w/ Line Relocation Bracket #SS26MV and they said that it is normal to have different amount of spacers on each side and they recommend you leave it as is, as to much compression…

view full answer...

Answer 11

The SumoSprings Trailer Helper Springs #TSS-107-40 are designed for single axle trailer applications, so for your tandem axle travel trailer, you'll just need two of these kits. These SumoSprings will fit your 2016 KZ Sportmen travel trailer as…

view full answer...

Answer 12

If the U-bolts are 9/16 inch diameter, the torque specs should be between 65 to 95 foot lbs. If the U-bolts are 3/8 inch diameter, the torque should be between 30 and 50 foot lbs.

view full answer...

Where Do the 2 White Freeze Wires Go When Swapping Coleman for Furrion Chill AC

Continue Researching