Can Conventional Ramp Door Spring # ERS120D81 Be Shortened
Updated 12/02/2020 | Published 11/30/2020
Question:
I am looking for the specific dimension between the spoils on the ERS120D81. I see 81” but I need to know also if that dimension can be shortened and if so, how much? Thank you.
asked by: Jason
Expert Reply:
The Conventional Ramp Door Spring # ERS120D81 can be shortened quite a bit actually as you can loosen the brackets that hold the coil of the spring and mount which is attached to the spool can be loosened and slid inwards to make the setup quite a bit shorter. Overall the setup is 81 inches but if you needed it to be shorter you certainly could.
Product Page this Question was Asked From
Conventional Ramp Door Spring for 7' Wide Enclosed Trailer - Dual Spring - 120-lb Capacity
- Trailer Ramp Springs
- Dual Ramp Spring
- Torsion Spring
- 150 Inch Cable
- 86 - 120 lbs
- Conventional Spring
- 6 Foot Wide Trailer
- 7 Foot Wide Trailer
- 81 Inch Wide Spring
- M-3 and Associates
more information >
Continue Researching
- Q&A: How to choose the correct conventional ramp door spring
- Q&A: Swing Away Tongue Kit For A 3" x 3" Trailer Tongue
- Q&A: Weight Capacity Options for a 6 ft. Wide Ramp Door Spring
- Q&A: Choosing the Correct Replacement Spring for an Enclosed Trailer Ramp Door
- Q&A: Weight of Enclosed Trailer Ramp Spring ERS120D81
- Q&A: Is etrailer Still Carrying Draw-Tite Hitches
- Q&A: Choosing/Sizing the Correct Trailer Ramp Spring for a Ramp Door
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: What Does it Mean When an RV is Solar Ready?
- Article: Trailer Wiring Diagrams
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box