Is .5 Volt At 4-Way Connector Normal After Curt Trailer Wiring Install Harness
Updated 11/04/2020 | Published 11/03/2020
Question:
Just installed trailer wiring kit . Curt 56127. There is always 0.5 volts at each prong at the plug when testing. Pull the 10 A fuse at battery and there are zero volts to plug. Otherwise, it seems to work properly . I get 12 plus volts at light prong, 12 volts at brake lights and meter pulses on blinkers.
asked by: Mark W
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Comparing Trailer Wiring Options for a 2008 to 2012 Mitsubishi Lancer
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: Recommended Trailer Wiring Harness for a 2015 Mitsubishi Outlander Sport W/O Factory Towing Package
- Q&A: Replacement Hub Recommendation for Dexter Hub 8-258
- Q&A: Method for removing and Installing Tang-Style Spindles Washers
- Q&A: Power Distribution Stud Nut Sizes for Installing a Brake Controller on a 2007 Chevy Silverado
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Troubleshooting Trailer Wiring Not Functioning Properly on 2014 Mitsubishi Outlander
- Article: Routing the Power Wire for a Trailer Wiring Harness