Can the Pacer Performance Cab Light Kit be Wired to the Running Lights
Updated 10/12/2020 | Published 10/08/2020 >
Products Featured in This Question
Question:
I bought these cab lights but don’t want to use the toggle switch. Wondering if there’s a way to wire directly to running lights, if so do you have any instruction? The truck I’m mounting them on has never had cab lights in case that matters.
asked by: Zach C
Expert Reply:
They do not provide instructions for wiring the Pacer Performance Hi-Five LED Truck Cab Light Kit part # PP20-236 directly to the running lights but it is very possible. Basically you need to use a probe tester like part # PTW2993. This will allow you to check the wiring behind your headlight switch to determine which wire is for your running light circuit. You will test the wires with the running lights only on and see what wire is hot. Then turn them off if it loses signal it is the one you want.
Splice your wire from the cab light that would normally go to the toggle to the running light wire and you will be set.
Product Page this Question was Asked From
Pacer Performance Hi-Five LED Truck Cab Light Kit - Ford - 5 Piece - Amber LEDs - Amber Lens
- Vehicle Lights
- Marker Light
- Cab Light
- Multiple Lights
- LED Light
- Light Assembly
- Rectangle
- Amber
- Pacer Performance
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Correct B&W 5th Wheel Setup For 2026 Ford F-350 Short Bed Towing 2027 Brinkley Z 3610
- Q&A: Looking for Replacement 36 inch Fireplace for 2021 Holiday Rambler Armada 44LE
- Q&A: Recommended Replacement for a Norcold 2118X Refrigerator
- Q&A: Axletek-12-GG Replacement Brake Assembly and Hub Recommendation
- Q&A: Replacement Powered RV Stabilizer Jack for Lippert 369777
- Q&A: Replacement Refrigerator for a Dometic RM2551
- Q&A: Availability of Running Boards for 1997 Ford F-250 HD SuperCab
- Article: Trailer Lighting Requirements

