Individual Slide Motor Switch Compatibility with 3 Slide Outs on 2004 Keystone Challenger
Updated 10/01/2020 | Published 09/29/2020 >
Products Featured in This Question
Question:
I have a 2004 Keystone Challenger with one switch that operates all 3 slides. Is it possible to change to individual switches with same motor and hydraulic actuator setup.
asked by: Matt L
Expert Reply:
Thu number of switches you can use depends on the number of motors. It sounds like you only have the option of one switch because a single motor activates all three. If I misunderstood and each slide has its own motor and hydraulic actuator, then you can use Triple Bezel RV Switch Faceplate - White # 37213625 along with the Single RV Switch - On/Off/On - SPDT - Polar White # 37213435. Then I recommend using # 10-1-1 wire to connect to the circuit breaker or battery and # 10-2-1 wire to connect to each motor.
Product Page this Question was Asked From
Lippert Slide-Out Switch Assembly - Black
- RV Slide Out Parts
- Controller Parts
- Switch
- Lippert Above-Floor Slide-Out Systems
- Lippert Through-Frame Slide-Out Systems
- Black
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Looking for Replacement Microwave for High Pointe EC028KD7
- Q&A: Wiring Diagram for the JR Products Single Slide-Out Switch
- Q&A: RV Fireplace Replacement for EF30B in RV
- Q&A: Air Conditioner To Replace RVP Air Conditioner Model 8333D876 Ducted System
- Q&A: Replacement Key For a Latch Lock That Has a M315 on it
- Q&A: Is The Lippert Slide Out Switch LC117461 A 4 Wire Or 5 Wire Switch.
- Q&A: Replacement Converter for 45 Amp Magnetek 6345
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Sidewinder with Rotating Turret for Short Bed Pickups


