Troubleshooting Leveling System Error on Starting With Disconnecting Battery
Updated 09/09/2020 | Published 09/05/2020
Products Featured in This Question
Question:
where is the 12V electrical panel that I would disconnect for 15 minutes? all lights blinking on the leveling system.
asked by: Jimmy D
Expert Reply:
You are looking for the Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System # LC304136 to disconnect the system from the battery. This control module is normally located inside a compartment toward the front of the trailer. Disconnecting the Battery for 10-15 minutes lets the leveling system reboot and then you can do a fresh zero point calibration and further testing as needed at that point. The control module supplies power to the panel and from the panel to the individual jack motors.
Product Page this Question was Asked From
Replacement Lippert Control Panel with Amp Connector for 4-Point Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Controllers
- Control Panel
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Video: Review of Lippert Replacement Ground Control 3.0 Electric Leveling System Control Module - LC304136
- Video: Lippert Ground Control 3.0 Electric Leveling System Replacement Control Module Review
- Q&A: Troubleshooting LR Error Code of Lippert Ground Control 3.0
- Q&A: Availability of Replacement Control Module for 694654
- Q&A: Replacement Control Module for Lippert Ground Control System that Errors Out
- Q&A: Troubleshooting A Lippert Ground Control 3.0 Leveling System That Isn't Operating
- Q&A: Correct Replacement Control Panel/Control Module for Lippert Ground Control 3.0 Leveling System
- Q&A: Lippert Ground Control Comm Error Check Wiring Troubleshooting
- Q&A: Replacement Module for Lippert Ground Control 694656