Where To Drill Hole in Bed of 2010 Ford F-150 Short Bed to Install B and W Turnoverball Gooseneck
Updated 07/29/2020 | Published 07/27/2020
Question:
What is the measurement to drill hole in bed of truck. 2010 F150 6 1/2’ bed
asked by: Ronnie B
1
Helpful Expert Reply:
You'll need to measure 45-1/8 inches forward from the rear truck bed edge of your 2010 Ford F-150 short bed forward to determine the location of where to drill when installing the # BWGNRK1104.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Flip-Over Ball
- 7500 lbs TW
- 30000 lbs GTW
- Wheel Well Release
- Spring-Loaded Loop
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can My 2024 Ford F350 SRW 6.7L Diesel Safely Haul A Grand Design Influence 3003RL?
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: What Air Suspension is Compatible with 2012 Ford F-150 FX4 with B&W Gooseneck Installed?
- Q&A: Availability of Jack Screw for Bulldog Square Jack
- Q&A: Which Gen-Y Gooseneck Adapter Fits 2024 Brinkley Z-3100
- Q&A: Does The Gen-Y Gooseneck Pin Box # GY33GR Have An Auto-Latch Coupler
- Q&A: Troubleshooting Nose-High Towing With A Grand Design Solitude 5th Wheel Trailer
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Titan Hydraulic Trailer Parts
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Wiring Diagrams