How Does the Replacement Vacuum Pump for Dometic Toilets Connect On the Intake Side
Updated 07/13/2020 | Published 07/09/2020
Question:
On the tank side of the vacuum generator intake side of pump p/n 385311595 does the white fitting just slide into the holding tank? It doesnt appear to be threaded. I do see two o-rings on your photo on that piece.
asked by: Sim L
0
Expert Reply:
That is correct. The intake pipe on the # DOM33FR is not threaded, but instead has two rubber gaskets to ensure a water tight seal on the pipe.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Replacement Vacuum Pump for Dometic VacuFlush RV Toilet - 12V
- Accessories and Parts
- RV Toilets
- Vacuum Parts
- Vacuum Pump
- Dometic
more information >
Continue Researching
- Search Results: locations
- Shop: Replacement Vacuum Pump for Dometic VacuFlush RV Toilet - 12V
- Video: Checking Out the Replacement Vacuum Pump for Dometic VacuFlush RV Toilet
- Shop: Replacement Bellows for Dometic Boat Vacuum Pump and Discharge Pump
- Q&A: Replacement Parts For Dometic Sealand Boat Vacuum Pump and Discharge Pump
- Search Results: boat trailer fenders
- Shop: CE Smith Single Axle Trailer Fender - 16 Gauge Steel - 12" Wheels - Qty 1
- Q&A: Replacement Vacuum Pump 385311595 for Dometic VacuFlush RV Toilet
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Q&A: Replacement Kwikee Control Box 90950600 for Electric RV Steps
- Q&A: Fit of Lippert Components Kwikee 34 Series Replacement Motorized RV Steps LC3722863
- Q&A: What Does IMGL and Pre-IMGL Mean for Lippert Kwikee Steps
- Q&A: Are Replacement Parts Available for Vacuum Pump for Dometic VacuFlush RV Toilet
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Measure for Trailer Hitch Drop
- Article: Roadmaster Vehicle Specific Base Plates
- Article: RV Sway Control, Stabilization, and Suspension Enhancement