Fastener Opening Size of 337B2374GZ Bolt-On Stake Pockets
Updated 07/10/2020 | Published 07/08/2020
Question:
Hello. What size carriage bolts are needed for these trailer stake pockets? Thank you.
asked by: Christopher S
0
Expert Reply:
The square opening for the fastener on the # 337B2374GZ is 7/16 of an inch square. The size and length of the carriage bolt will depend on what sort of the material you're attaching the stake pocket to, but the carriage bolt should have a 7/16 inch shoulder on it. I've provided some photos that should help make this clearer.
expert reply by:
Mike L
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Buyers Products Stake Pocket for Flatbed Truck or Trailer - Bolt On - Zinc - Qty 1
- Trailer Tie Down Anchors
- Stake Pockets
- Zinc-Plated Steel
- Bolt-On
- Fixed
- Buyers Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: How Many Weld-On Stake Pockets # HW03-080 to Install on Each Side of 12-Foot Trailer
- Q&A: Is There a Replacement Spindle For a Dexter D44, 4400LB Trailer Axle?
- Q&A: 12V Converter Recommendation for RV to Power MaxxFan Dome Roof Vent
- Q&A: Is There a 30 Amp, 12 Volt Power Converter
- Q&A: Is It Required The Spring Seat Be Welded to Trailer Axle
- Q&A: Comparing Steel Gauge Thickness For Bolt On 2 x 4 Stake Pockets
- Article: Trailer Tire Sizing
- Article: Rooftop Cargo Carriers
- Article: Performance Chips and Modules