How Many Weld-On Stake Pockets # HW03-080 to Install on Each Side of 12-Foot Trailer
Updated 05/04/2015 | Published 05/02/2015
Question:
My trailer is 12ft long. I wont to install p/n HWO3-080 stak pockets. How many per side?
asked by: John H
1
Helpful Expert Reply:
You can install as many of the Redline Weld-On Stake Pockets # HW03-080 on each side of your flatbed trailer as you need to properly support the load. In general 1 stake pocket per 3-foot section of trailer, or 4 per side in your case, should be sufficient for many applications but you will have to determine this for yourself.
expert reply by:
Adam R
1
Product Page this Question was Asked From
Trailer Weld-on Stake Pocket - 6 Gauge
- Trailer Tie Down Anchors
- Stake Pockets
- Universal
- Steel
- Weld-On
- Fixed
- Surface Mount
- etrailer
more information >
Continue Researching
- Q&A: Brake Controller Wiring Harness on 2026 Ford F-250 WT
- Q&A: Bolt Recommendations for a Equalizer for 2 inch Slipper Springs
- Q&A: Comparing Lippert Never-Fail Bushings to the Bronze Bushings and Wet Bolt Option for Tandem Axles
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: 12 Inch Long Equalizer For 2 Inch Slipper Springs & 8,000 lb U-Bolts For Tandem Axle Trailer
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Tool to Drive in 2.72" Hub Dust Caps
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams