Replacement White Awning Extension Rod for Solera Slide Topper  

I recommend replacing the Extension Rod for your slide topper. With your current rod being bent even if you were able to bend it back straight it will more easily bend in the future or could break. We have the following extension rods for the Solera…

The length of the Lippert #LC2724392 is 15-3/8 inches. I confirmed this with my contact at Lippert. The holes are 5/8 of an inch from the end of each side of the rod as well.

When winding awning rollers like the Solera RV Slide Out Awning part #LCV000163285 you wind them towards the RV. So like if the roller was on the ground the direction you'd roll the tube would be the direction that would roll the tube towards the…

Yes, the Replacement Awning Extension Rod for Solera Slide-Topper Awning #LC3452072 that you referenced measures 3/4". I actually recently took this same measurement for another customer for the white version part #LC3452071 and I'm…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…