Can You Replace Just the Valve When Upgrading To Electric Sewer Waste Control
Updated 06/30/2020 | Published 06/26/2020
Products Featured in This Question
Question:
Can you only replace the waste valve with the Vaterra electric valve? Do you have to install the whole assembly, electric valves and drain pipes?
asked by: Larry S
Expert Reply:
In order to upgrade from manual to electric waste control valves you'll need to change out the entire housing/body as well. For this, we have quite a few options which will depend on if you have separate valve like part # E40B-8 or combined like part # E85-8. These options both have hub fittings which are the easiest to change out since all you need to do is cut the old ones off and slide the new ones on with some solvent part # A05-0303.
Product Page this Question was Asked From
Valterra EZ Valve Electric Waste Valve for RV Black Water Tank - 3" Hub to 3" Hub
- RV Waste Valve
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Electric
- 3 Inch Hub
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Recommended Soft Start for a Furrion AC Unit
- Q&A: Can Furrion Vision S+ Monitor Be Powered By USB
- Q&A: What Is The Shoe In A Schwintek Slide Out System And What Does It Do
- Q&A: Can Valterra EZ Valve Electric Waste Valve Be Installed Sideways Under 5th Wheel Trailer
- Q&A: Replacement Microwave for a High Pointe EM925AWW-B
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: Wiring An Atwood RV Water Heater With Double-Panel On/Off Switch
- Article: Converting Your RV Water Heater to Tankless
- Article: What Does it Mean When an RV is Solar Ready?
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Can You Flat Tow a Ford Escape?
- Article: Ram Trailer Tow Prep Package
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)