Installation of the Door Check and Hold Back part # 337BM2395AA11
Updated 07/10/2020 | Published 06/26/2020
Question:
I just received these brackets. They look to be of high quality. What screws would you recommend I use to install them? Thanks, Doug Schulte
asked by: Doug S
Expert Reply:
The Buyers Products Door Check and Hold Back part # 337BM2395AA11 can be installed with many types of hardware depending on the surface you're mounting it to.
When mounting to a very heavy material like very thick ply wood or a thicker steel using some #12 or #14 self tappers would be a fine solution. If you're going into thinner material You will need to use bolts with large washer to spread out the energy over a greater area. There are no written instructions for this because there are so many different materials it can be mounted to.
Product Page this Question was Asked From
Buyers Products 90-Degree Door Check and Hold Back - Spring Loaded
- Accessories and Parts
- RV Door Parts
- Door Holder
- Buyers Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Suspension Enhancement
- Search Results: flat tow wiring harness
- Search Results: 7 way rv to 6 pole
- Search Results: 7 pin to 5 pin round adapter
- Search Results: hitch tightener
- Video: A Closer Look at the Trimax Universal Anti-Rattle Clamp for Class III and IV Trailer Hitches
- Shop: Timbren Front Suspension Enhancement System
- Shop: Buyers Products 90-Degree Door Check and Hold Back - Spring Loaded
- Video: An In-Depth Look at the Buyers Products 90-Degree Door Check and Hold Back
- Shop: Dexter Self-Contained Hydraulic Jack- Square Tube - Bolt On - 12,000 lbs
- Shop: Timbren Rear Suspension Enhancement System
- Q&A: Where to Install Buyers Products Door Check and Hold Back
- Search Results: timbren
- Shop: Vehicle Tow Bar Wiring
- Shop: Trailer Wiring
- Video: Checking Out the etrailer Anti-Rattle Hitch Stabilizer for 2" Hitches
- Video: A Closer Look at the etrailer Anti-Rattle Hitch Collar on a 2023 Fleetwood Discovery LXE Motorhome
- Video: Detailed Breakdown of the Roadmaster Quiet Hitch for 2" Trailer Hitches
- Video: Blue Ox Hitch Receiver Immobilizer Road Test
- Video: Review of the Gen-Y Anti-Rattle Clamp for 2-1/2" Hitch Receivers
- Search Results: utility trailer plans
- Shop: Vehicle Cargo Control
- Shop: Blue Ox Hitch Receiver Immobilizer II - 2-1/2" Hitches
- Shop: Curt Anti-Rattle Hitch Clamp for 2-1/2" Hitches
- Shop: RoadMaster 6-Wire Flexo-Coil Kit
- Q&A: What Other Parts Are Needed To Install The Dexter Self-Contained Hydraulic Jack DX72CR
- Search Results: battery box
- Shop: RV Interior Lighting
- Q&A: Recommended Fluid For The Dexter Self-Contained Hydraulic Jack # DX72CR
- Q&A: How Does Buyers Products Door Check and Hold 337BM2395AA11 Get Installed?
Michael C.
7/6/2020
Not sure exactly how to install is there a video I can see to install this is a short spring go to the inside or outside no directions really don't know how to install it