Can an Electric Trailer Brake Controller be Installed on a 2007 Acura MDX

Updated 08/23/2012 | Published 08/22/2012

Products Featured in This Question

Draw-Tite Activator IV Trailer Brake Controller - Up to 4 Axles - Time Delayed

(357)

$103.31

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(126)

$36.74

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3395)

$121.25

Question:

are there any issues with installing this controller on a 2007 acura mdx? e.g., will instalation affect antilock or vehicle stability systems? if not, which color brake switch wire should be used on this vehicle

asked by: PAUL H

Expert Reply:

You can install the Draw-Tite brake controller # 5504 on a 2007 Acura MDX. There are a few parts that you will need. First, if the vehicle does not already have a 4-Way trailer connector, you will need to add one using # 118424.

Once the 4-Way is installed or if you already have a 4-Way installed, you will need 4- and 7-Way installation kit # ETBC7. This will provide the 7-Way trailer connector and the wiring for the brake controller. I have included some instruction links and video that should help.

When it is time to install the brake controller red wire for the brake switch, you will need to use a circuit tester, like # PTW2993 if needed, to test the wires on the brake switch above the brake pedal. The correct wire could be a white and black striped wire, but you will need to test to be sure.

Use the circuit tester to find the wire that carries a signal only when the brake pedal is pressed and not one that also shows a signal when the headlights or turn signals are on. Once you have located the correct wire attach the brake controller red wire to it.

This installation should not interfere with the ABS or stability systems on the vehicle.