Replacement Brass Bushing and Rod for 12,000 lb Fulton Jack

Updated 06/05/2020 | Published 06/03/2020

Question:

I have a Fulton 12000 lb Jack. The brass nut stripped out on the rod and wondering if you have a replacement. All the rods Ive found bolt in and this one sits inside the tube with the corners punched in the hold it in place.

asked by: Devin O

Expert Reply:

The Replacement Handle Shaft for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
# TJD-12000-SHABUS although not a direct replacement is my recommendation for your Fulton Jack. We don't have the replacement parts you described, but this will actually give you a better brass bushing to minimize the possibility of this same issue happening again. I've attached a video to help.

If you are needing a new threaded screw rod and nut, then I recommend the Replacement Screw and Nut Assembly for Bulldog Square Jacks - 10K TW # BD500250. I've attached a video of this for you to check out regarding the fit with your Fulton Jack.

If this doesn't work with your jack, you may want to consider replacing the jack as Fulton no longer makes the large capacity square jacks.

expert reply by: Jason S