Troubleshooting Brake Controller Install Where Brake Pedal No Longer Activates Brakes
Updated 06/04/2020 | Published 06/03/2020 >
Question:
I have the Insight controller and Ive used it before in the same year make and model vehicle and have now put it in a different vehicle of the same year make and model. Heres my problem, I have no power to the 7-way blue connection via the brake pedal, I do however have power to the 7-way blue connection using the slider. Where have I gone wrong this time?
asked by: Jim L
Expert Reply:
The issue is the red wire of the brake controller install. It needs to be connected to a circuit that sees voltage when only the brakes are applied. It sounds like this connection isn't made in your new vehicle or the connection isn't solid enough.
I also attached a help article on brake controller troubleshooting for you to check out as well.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Q&A: Looking for Replacement Hydraulic Gear Pump 196895
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Activate 12V Trailer Power Circuit on 2017 Ford F-350 Super Duty
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today


