Floor Thickness Requirement for the Tow-Rax Wheel Chock Part # TWSPWM
Updated 05/07/2020 | Published 05/05/2020
Question:
For Item # TWSPWM, is there a requirement for the wooden floor thickness? My trailer floor is 3/4inch plywood.
asked by: Troy J
Expert Reply:
When installing the Tow-Rax Removable Wheel Chock w/ Wood Screws part # TWSPWM there really isn't a set material thickness it needs to be in. It does not carry any type of weight rating. It is meant to act as a stop for your wheel and to keep it from moving side to side as you are heading down the road. The 3/4" plywood you intend to mount it to will work out great. i would not trust anything under 1/2" in this situation.
Product Page this Question was Asked From
Tow-Rax Removable Wheel Chock w/ Wood Screws - 6-1/2" Wide Tires - Tubular Steel - Black
- Wheel Chocks
- Wheel Chock
- Motorcycle
- Steel
- 1 Chock
- Black
- Tow-Rax
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will the Set Screws Sit Flush on the 3" Gen-Y Anti-Rattle Reducer Sleeve?
- Q&A: How to Secure a 2018 Harley Davidson Tri Glide to a Trailer
- Q&A: Where Are Mighty Cord Power Cords Made?
- Q&A: Replacement Motor for Kwikee Motor Assembly 214-1009
- Q&A: Inside Width of Tow-Rax Removable Wheel Chock
- Q&A: Replacement Hub for AxleTek Hub # BD2-545-17
- Q&A: Looking For Replacement MasterPro 581750 Hubs On A Yacht Club Pontoon Trailer
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: What Do I Need To Tow A Trailer?
- Article: RV Sway Control, Stabilization, and Suspension Enhancement