Replacement Passenger Side Boat Trailer Taillight Assembly

Question

Question:

Hello. I need the correct replacement part number for the passenger side tail light. See attached pics.

asked by: Derrick H

0

Expert Reply:

Given the photos you've provided, it looks like the replacement lamp you're needing is part # ST66RPG for the passenger side for an incandescent lamp or # STL36RPG for an LED version. The LED version has a 2 pin plug with a separate ground connection that would ground to the trailer frame, or you could cut the connector off your existing lamp and swap them.

expert reply by: Mike L

0

click to enlarge

Answer 1

The Wesbar 271594 is a sealed light which means the lens is not replaceable. The only solution is to replace the entire light. The parent company for Wesbar recently changed, so as of May 2023 this particular light is on indefinite backorder. I…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Replacement Passenger Side Boat Trailer Taillight Assembly

Products Featured in This Question

Continue Researching