Will the Replacement 2" Receiver for Curt Multi-Ball Ball Mount Work With Weight Distribution Shank
Updated 04/29/2020 | Published 04/28/2020
Products Featured in This Question
Question:
I want only a short 2-3 inch drop, need to match the shank to my weight distribution hitch which has a 5-9 inch , nothing less. How far apart are the holes where the two bolts go into?
asked by: Wayne
Expert Reply:
In regards to the Replacement 2" Receiver for Curt Multi-Ball Adjustable Ball Mount part # C45802 which is a replacement for the Curt Multi-Ball Adjustable Ball Mount for 2" Trailer Hitches part # D900, the two holes are spaced 2-1/2" apart so it will work on a weight distribution shank, you'd just need the Replacement Tri-Ball for Curt Adjustable Ball Mount part # C45800.
Product Page this Question was Asked From
Curt Multi-Ball Adjustable Ball Mount for 2" Trailer Hitches
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- Three Balls
- 1-7/8 Inch Ball
- 2 Inch Ball
- 2-5/16 Inch Ball
- Steel Shank
- Drop - 6 Inch
- Rise - 4 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- CURT
more information >
Continue Researching
- Q&A: Distance From Center Of Hitch Pin Hole To Hitch Ball On Blue Ox Adjustable Ball Mount
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Are There Long-Term Service Contracts To Use PingMaster Trailer Tracking Devices?
- Q&A: Can Longer Shank Be Used With Buyer's Products 3371802225 Adjustable Ball Mount
- Article: Steel vs. Aluminum Ball Mounts
- Q&A: How to Find Out What Hitch Size is Installed on Your Vehicle
- Q&A: 7-Way to 4-Way Adapter with LED Resistor Solution
- Q&A: Purpose of Small Ball Mounted to Side of Trailer Tongue
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Dimensions of the B&W Tow and Stow 3-Ball Mount
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)