Replacement Plunger Pin for Fulton Swing Away Trailer Jack
Updated 04/23/2020 | Published 04/22/2020
Question:
I need a 3/8 plunger pin replacement for a Fulton Jack. The model number is not available. It is stamped for 800lbs cap. The straight part must be at least 2-1/2 to the end of the plate. Prob need more like 2-5/8 to project past the plate. It is for a utility trailer.
asked by: Chris
0
Expert Reply:
It sounds like you are seeking the Replacement 1/2" Plunger Pin Kit for Fulton Marine Jacks # F0933307S00 but you mentioned 3/8 inch. If that is the case, then I recommend the Replacement 3/8" Diameter Plunger Pin Assembly for Bulldog Jacks # BD500103 instead.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Replacement 1/2" Plunger Pin Kit for Fulton Marine Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- 1/2 Inch Plunger Pin
- Fulton
more information >
Continue Researching
- Video: Replacement Swivel Pin Kit for Trailer Jacks: The Breakdown
- Video: Feature Review Replacement Swivel Pin Kit for Trailer Jacks
- Q&A: Comparing the Dutton-Lainson Swivel Pin to the Fulton Swivel Pin
- Shop: Replacement Swivel Pin Kit for Trailer Jacks
- Shop: Replacement Plunger Pin Assembly for etrailer and Ram Jacks - 1/2" Diameter
- Search Results: jack parts
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Replacement Plunger Pin Assembly with 1/2 Inch Diameter
- Q&A: Replacement 3/8 Diameter Plunger Pin Assembly
- Q&A: Recommended Trailer Winch for Scissor Lift Pontoon Trailer
- Q&A: Plunger Pin Replacement for a Shelby Model 5856A Trailer Jack
- Q&A: Is There A Snap Ring Jack With A Wheel That Uses a 1/2" Pin For The Mounting Plate?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices