Hole Size Needed to Install the Optronics Sealed 4 Inch Round Trailer Light # ST47RB
Updated 07/17/2012 | Published 07/13/2012
Question:
What size hole do I need to cut to mount a ST47RB light?
asked by: Jason
0
Expert Reply:
I pulled the Optronics Sealed 4 Inch Round Trailer Light, # ST47RB, from the warehouse and measured the diameter of the light housing that will be recessed in the trailer. It measures 4.44 inches in diameter so a 4-1/2 inch hole should be fine.
I spoke with my contact at Optronics and they do not recommend a specific hole diameter for this light, but most flange and flush mounted 4 inch lights require a 4-1/2 inch diameter hole.
expert reply by:
John H
0
Product Page this Question was Asked From
Optronics Trailer Tail Light - Stop, Turn, Tail - Round - Grey Flange - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 5-1/2 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: What Hitch will Not get in the Way of My 2025 Subaru Forester Hands Free Lift Gate?
- Q&A: Adapter Plug For Optronics ONE LED Tail Light
- Article: Trailer Lighting Requirements
- Q&A: What Amber Clearance Marker Will Fit an ATV Trailer With 2.5" Hole?
- Q&A: Compatibility of Replacement Landing Gear Motor # LG-142178 with Original on Keystone 5th Wheel
- Q&A: Replacement Tail Lights for a 2008 Featherlite 4926 Car Hauler Trailer
- Q&A: Does Dual Ramp Door Spring Turn Each End Independently
- Q&A: Running Hot-Line LED Trailer Light Bar as Brake Light Only
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Trailer Hitch Drop
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)