Where is the Draw-Tite Hitch for a 2007 Ford F-150 Made
Published 04/08/2020
Products Featured in This Question
Question:
Is the hitch US made? If not, where is it made and do you have any that are US made?
asked by: Tom L
0
Expert Reply:
The Draw-Tite Max-Frame Trailer Hitch Receiver part # 75506 which is a fit for a 2007 Ford F-150 is made in Mexico. If you are looking for a USA option, the Curt Trailer Hitch Receiver part # C13360 is the way to go. If you need a trailer connector to go along with the trailer hitch, the Curt T-Connector Vehicle Wiring Harness part # C56031 is plug-n-play.
expert reply by:
Conner L
0
Continue Researching
- Q&A: Recommended Trailer Hitch Receiver For 2013 Volvo S60
- Q&A: What Is The Inside Flange Width Of The TowSmart Trailer Hitch TS46VR?
- Q&A: Tow Package Fuse and Relay Locations for 12 Volt Power on a 2006 Ford F-150
- Q&A: Troubleshooting Brake Controller that Reads 0.0 Occasionally When Brake are Applied
- Q&A: Does Curt Hitch part # C14360 Fit 2008 Ford F150 STX
- Q&A: Why is the Rise Measurement Different From the Drop Measurement on Ball Mounts
- Q&A: Class IV and V Trailer Hitch Options for a 2006 Ford F-150 STX
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch