How are Spacers Used When Installing Cam-Action Lockable Door Latch Kit # PLR458-018
Updated 04/06/2020 | Published 04/05/2020
Question:
I purchased this kit PLR458-018, but have not been able to figure how to install the spacers. How are the spacers attached? Are they also welded onto the pipe?
asked by: Paul
Expert Reply:
I attached a picture that shows the spacers lined up on the cam door latch # PLR458-018 to show you where they install. They basically install in between the top and bottom bar clamps and the latch system on top. This is designed to prevent the bar from sliding down when it's not latched. I've used these before and they have a tendency to slip down if they don't have the spacers holding them in place.
Product Page this Question was Asked From
Cam-Action Lockable Door Latch for Large Enclosed Trailers - 2 Point - Zinc-Plated Steel
- Trailer Door Latch
- Reversible
- Cam-Action Latch
- Lock Not Included
- Bolt-On
- Zinc-Plated Steel
- Polar Hardware
more information >
Continue Researching
- Q&A: Replacement Coupler Parts
- Q&A: How Does the Pipe Attach to the Cam Lock Assembly on Polar 658-002?
- Q&A: What Size Hardware Is Used To Install The Buyers Hitch Plate 3371809061A?
- Q&A: Availability Of 33" Ark Stabilizer Jack And Dimensional Diagrams Of Similar Ark Corner Steadies
- Q&A: Recommended Side Door Latch For An Older Haulmark Enclosed Trailer
- Q&A: Is There a Trailer Wheel with a 5 on 4-1/4 inch Bolt Pattern
- Q&A: Submersible Amber Light
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Lighting Requirements
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited