Will the Air Lift LoadLifter Air Springs for a 2010 Chevy Silverado 1500 Lift the Truck Unloaded

Question

Question:

can I use this product to lift the rear of the truck 3 ish inches even with no load in bed or hitch, I just need some ground clearance for the Tow and Stow hitch I bought?

asked by: Mark

0

Expert Reply:

The Air Lift LoadLifter 5000 Ultimate Plus Air Springs part # AL88204 which is a fit for a 2010 Chevrolet Silverado 1500 is not designed to raise the ride height. That said, if you were to inflate the air bags without weight in the bed or attached to the trailer hitch then the rear of the truck would indeed lift up. I don't have an exact amount of lift provided as it will vary based on the psi and again the system isn't designed to lift the truck. However, I can say around 1" of lift is within the realm of possibility but I doubt it would get near 3".

Please note, the ride quality while riding around with the system inflated and the truck unloaded would be harsh. It would however provide great support while towing and reduce sag.

expert reply by: Conner L

0

Answer 1

So there is a really good option for suspension enhancement for your 2018 GMC Sierra 1500 4x4 that won't affect the unloaded ride (and will even improve it), but the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Will the Air Lift LoadLifter Air Springs for a 2010 Chevy Silverado 1500 Lift the Truck Unloaded

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching