Plug Needed for Water Lines On Outdoor Sink In Trailer
Published 03/25/2020
Products Featured in This Question
Question:
I am looking to plug the water lines to the sink faucet in my RVs outdoor kitchen, which I am removing. Is this the correct size? Thank you.
asked by: Tim
0
Expert Reply:
The Valterra Pipe Plug part # RF865 is designed for a 3/8" NPT Fitting. If this is what you have then it will work well just don't forget pipe tape part # A05-0265. Unfortunately, I don't know what size water lines are on any one specific trailer but all you would need to do is measure the fitting size. The female fitting should measure around 5/8" diameter for a 3/8" male fittings.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Valterra RV Water Tank Plug - 3/8" MPT - ABS
- Accessories and Parts
- RV Fresh Water Tank
- Plugs
- Valterra
more information >
Continue Researching
- Q&A: Which Direction Should I Mount the Lippert Scissor Stabilizer Jack LC285325?
- Q&A: Highest Capacity Scissor Jacks
- Q&A: Recommended Replacement RV Scissor Jacks
- Q&A: Can Stabilizer Jacks be Used to Lift RV a Little
- Q&A: Shank For Fastway e2 Weight Distribution That Fits 2-1/2 Inch Hitch Receiver
- Q&A: What Is Needed To Flat-Tow 2011 Kia Soul With manual Transmission Behind Motorhome
- Q&A: Recommended Replacement For A Broken LaSalle Bristol Cable Actuated Waste Valve
- Article: Stability Control for Heavy Duty Vehicles
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Performance Chips and Modules