Recommended Class IV Trailer Hitch for 1996 Chevy K1500 That Fits Tight to Bumper  

I do have an option for you but I cannot recommend you add any spacers in between the trailer hitch and trailer frame as this would affect the integrity of the trailer hitch. Therefore, if the Curt Trailer Hitch Receiver part #13028 does not clear…

The distance from the crosstube to the very end of the receiver is 8 inches for the Curt Trailer Hitch Receiver #C14082.

Because the mounting flange of the Curt #C15511 Class V hitch has 3 tabs on each side, rather than a continuous mounting flange like many other hitches, it'll fit around the rivet shown in your photo. However, be aware that the Curt #C15511 is a…

The Curt Trailer Hitch Receiver part #13028 could potentially fit your 1966 Chevrolet C10 with aftermarket bumper. However, I would not be able to confirm this as the trailer hitch is only tested with the OEM bumper. I have attached a photo for you…

As we have not had a 1973 Ford F-100 in our shop to test fit the available receivers I can only give you the measurements from one of our receivers so that you can see where it will sit on your truck. The Curt Trailer Hitch Receiver #C14082 is…

I went out to the warehouse to take some measurements of Curt trailer hitch #C14082. I made a picture showing the measurements for you. The bolt holes, starting from the one furthest forward on the vehicle, measures 2-3/4 inches to the center of the…

We do offer hitches for your lowered 1999 Chevy C3500 dually that can be seen on the linked page. These include Class III, IV and V hitches, both 2-inch and 2-1/2-inch sizes. I'd recommend, Draw-Tite Hitch #37133. It is a Class III hitch that…

I'm going to assume you have the standard or step bumper on your 1990 Chevy C10 Single Cab, and the hitch I recommend for your truck is an option from Draw-Tite: - Draw-Tite Max-E-Loader Trailer Hitch Receiver #41524 I like the #41524 the most…

Your frame dimensions are consistent with a standard style of truck bed and not the cab and chassis models which have an OUTSIDE frame dimension of 34 inches. So the Curt hitch part #C14081 that you referenced would fit and work well. I attached a…

For a trailer hitch confirmed as a fit for your 1991 Chevy C1500 the Curt hitch part #C14081 is a confirmed fit. It would have more than enough capacity for your trailer as well. The gross vehicle weight rating (GVWR), or gross vehicle mass (GVM) is…

Curt Class IV trailer hitch #C14081 takes a 5/8 inch diameter pin the same as a Class III hitch. The outer width of the receiver is the same as well so the pin or lock does not have to be any longer. You can use your existing ball mounts that you…

The Curt Class IV, part #C14081 would work great for you. According to Curt, the spare will need to be dropped temporarily in order to facilitate the installation, but once the hitch is in place, the spare will fit back in its original location. This…