What Size Are the Studs For the Manager30 Battery Sensor
Updated 03/09/2020 | Published 03/07/2020 >
Question:
What size is are the studs on the battery sensor portion of this product? I need to prewire a battery bank. Thank you
asked by: Joseph C
0
Expert Reply:
In regards to the The Manager30 Battery Management System with Lithium Profile part # RED88FR, the studs on the battery sensor are 3/8 (9.5mm) in diameter.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Redarc The Manager30 Battery Management System with Lithium Profile
- Battery Charger
- Battery Charger
- Boat
- RV/Camper
- Trailer
- 12V
- Charges and Maintains
- AGM
- Calcium
- Gel
- Lead Acid
- Lithium
- Solar Panels to Auxiliary Battery
- Vehicle Battery to Auxiliary Battery
- Smart Charge
- Trickle Charge
- Redarc
more information >
Featured Help Information
Instructions
Continue Researching
- Article: 4-Step Guide to Installing RV Solar Power
- Article: How Much Solar Power Do I Need For My RV?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Battery Management System To Charge All Batteries Types On A Trailer From Solar, Shore, and Vehicle
- Article: RV Electrical Power Systems
- Q&A: Removing Rear Sag While Towing a Trailer with a 2018 Toyota Highlander
- Q&A: Recommended Replacement Converter For A Parallax 7300 Series Power Center
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Replacing Parallax 7355 Converter in 2004 Dutchman Travel Trailer
- Q&A: Replacement Converter For Parallax 7300 Series
- Q&A: Do I Need to Replace the Fuse Panel When Installing a PD4655V for Lithium Batteries?
- Article: How to Charge RV Batteries
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: The Best RV Battery Chargers

