Can the Furrion Automatic Transfer Switch Be Hooked Up to Shore Power and An Inverter
Updated 02/28/2020 | Published 02/27/2020
Question:
Hello, can this be used with a power inverter instead of a generator as the main power source, and then shore power for backup, and then be set to have instant transfer with only milleseconds delay, rater than 20 seconds, and also if the Power inverter eventually stops, will it instantly transfer back to shore power.
asked by: James
Helpful Expert Reply:
Yes, you can hook up a power inverter to input one and then shore power to input two on the Furrion Automatic Transfer Switch part # F30ATS. The dip switch will then need to be in the off position in order for the power to transfer instantly without delay when the inverter is turned off.
Product Page this Question was Asked From
Furrion Automatic Transfer Switch - 30 Amp - 120V
- RV Transfer Switch
- 30 Amp
- 120V
- Inverter to Generator
- Shore Power to Generator
- Furrion
more information >
Continue Researching
- Q&A: Wiring Instructions For The Furrion Automatic Transfer Switch
- Q&A: Transfer Switch to Bypass Inverter Wiring for When Not Using RV Battery for Power
- Q&A: Difference Between Go Power and Furrion RV Transfer Switches
- Q&A: Inner Width of SmartPlug RV/Marine Data Port Inlet
- Q&A: Is There a Difference Between The Progressive Dynamics PD1620A and Your Part # PD64FR?
- Q&A: Using the PD52 50 Amp Transfer Switch with 30 Amp Service
- Q&A: Will Rich Solar Kit Interfere With Shore Power Or Generator On Newer Jayco Camper?
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Replace an RV Roof Vent Cover
- Article: How Many Batteries Do You Need to Run an RV Air Conditioner?
- Article: Using a Portable Generator on RV
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Trailer Wiring Diagrams