What are Holes for on Valterra Lock and Global Link Entry Door Handle
Updated 02/20/2020 | Published 02/19/2020
Products Featured in This Question
Question:
Valterra Dead Bolt Lock. What are two holes drilled on the interior side of the latch used for? Global link door latch has two holes drilled in the handle on the interior side of the latch. What are they used for?
asked by: Denise W
Expert Reply:
The holes that are on the latch part of the Valterra Deadbolt Lock for RVs # L32CS3008 are used to connect the front and back portion of this particular lock.
The screw holes for the Global Link RV Entry Door Locking Latch Kit # 295-000002 are for installing and securing the latch portion of the kit.
I have added a link to a video review for you to check out as well.
Product Page this Question was Asked From
Valterra Deadbolt Lock for RVs - Single Cylinder - Stainless Steel - 5/8" Throw
- RV Door Locks
- Entry Door
- Deadbolts
- Keyed Unique
- Lock Core Only
- 5/8 Inch Long
- Silver
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Best Replacement for a Dometic R2131-BSPFMO Cooktop Oven
- Q&A: Looking For RV Range To Replace Dometic R2131-BBPFBO
- Q&A: Replacement Stovetop for Atwood 3-Burner Stovetop Gas Range
- Q&A: Side Wall Vent Recommendation for an Enclosed Trailer for Maximum Air Flow
- Q&A: RV door latch for enclosed cargo trailer
- Q&A: How to Use Custer Wireless Tow Bar with RV that has 6-Way Round
- Q&A: RV Deadbolt Installation In Door Without Deadbolt Holes
- Article: Stability Control for Heavy Duty Vehicles
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps