Is Drilling Required to Install the Pop and Lock Custom Tailgate Lock on a 2012 Honda Ridgeline
Updated 06/12/2012 | Published 06/09/2012
Question:
Does installation of the above tailgate lock require drillig a hole in the tailgate?
asked by: Vladimir
Expert Reply:
The Pop and Lock Custom Tailgate Lock, # PAL6100, does require drilling for installation, but you will not have to drill into the tailgate of your 2012 Honda Ridgeline. The installation instructions call for two 3/16 inch diameter holes (5 mm) and one 1/2 inch (12 mm) hole to be drilled into the back of the handle bezel.
The handle bezel will be exposed once you remove the trim piece on the inside of the tail gate. I have attached a photo showing how you will drill into the handle bezel.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Manual - Black
- Tailgate Locks
- Lock Only
- Manual Lock
- Keyed Unique
- Vehicle Specific
- Black
- Pop and Lock
more information >
Continue Researching
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Q&A: How to Wire Pop & Lock Tailgate on Honda Ridgeline Using Wiring Behind B-Pillar
- Q&A: What Is the Per Bike Weight Capacity of the Inno Velo Gripper Bike Rack for Truck Beds
- Q&A: Availability of Replacement Key for Pop & Lock Custom Tailgate Lock
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Tonneau Cover and Tailgate Lock Recommendation for a Honda Ridgeline with Factory Backup Camera
- Article: How to Measure for Trailer Hitch Drop
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)