How to Mount Optronics LED Backup Light # BUL23CB on a Trailer
Updated 06/04/2012 | Published 06/03/2012
Products Featured in This Question
Question:
How do you mount this light on a trailer?
asked by: Butch D
0
Expert Reply:
The Optronics backup light # BUL23CB, is a flush mount light. You would drill a hole 4-5/16 inches in diameter in the surface you wanted to mount the light to. You would then wire in the pig tail harness, # A49PB, to the trailer wiring. Then mount the light in the grommet, # A45GB, attach the wiring to the light and push it into the hole.
expert reply by:
Michael H
0
Product Page this Question was Asked From
DOT LED Backup Light for Truck or Trailer - Submersible - 27 Diodes - Round - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Round
- Recessed Mount
- Non-Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Q&A: Replacement Backup Light for Peterson 426E on Motorhome
- Q&A: DeeZee Brite-Tread Aluminum Running Boards for 2002 Ford Econoline Van
- Q&A: Will Pull Out Steps fit 2011 Palomino Puma 27KFQ
- Q&A: How To Lower a Trailer With Leaf Springs Or Torsion Axles
- Q&A: Suspension Upgrades For A 2011 Keystone Cougar 5th Wheel Trailer
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Front Mount Hitch Options For Ford E-450 RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Bleed Your Trailer Surge Brakes