How to Install the Uni-Lite LED Clearance and Marker Light
Updated 02/03/2020 | Published 02/01/2020 >
Question:
How to gasket into base
asked by: Mike
1
Helpful Expert Reply:
It sounds like you're trying to install the Uni-Lite LED Clearance and Marker Light # MCL11AKB, so you'll want to make sure that you have a 11/16" hole in the desired location. The grommet on this light should simply slip into the hole as long as it's that size (or relatively close), since the grommet is rubber it will compress a bit.
expert reply by:
Erik B
1
Product Page this Question was Asked From
Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: How Long is the DeeMaxx Trailer Wheel Lug Nut
- Q&A: What Size Socket is Needed for DeeMaxx Trailer Wheel Lug Nut
- Q&A: Replacement Axle For a Stealth 7.5X12 Cargo Trailer 3,500-lb 93.5" Hub Face 77.5" Spring Center
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Recommended Replacement Wheels for a Ranger Boat Trailer
- Q&A: Replacement Trailer Jack Recommendation for Dutton-Lainson Jack on Ranger Trailer
- Q&A: Recommended Replacement AC System for a GE ARH15AACBL2 AC Unit
- Q&A: Determining Spring Hanger Spacing for Tandem Axle Trailer Fabrication Project
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Store a Travel Trailer/Camper for the Winter
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller Installation: Starting from Scratch

