Availability of Rubber Grommet to Install Round Trailer Lamp in 3 Inch Rough Opening
Updated 01/04/2020 | Published 01/03/2020
Products Featured in This Question
Question:
Do you make a bezel or grommet for 2 inch lights that will fit a 3 inch hole
asked by: Brayden
0
Expert Reply:
We don't have a grommet that will secure a 2 inch lamp in a 3 inch rough opening, but the Optronics # A55GB rubber grommet will work with a 2-1/2 inch diameter lamp like the # MC57AB you'd looked at. The 2-1/2 inch diameter lamp is also available in red as part # MC57RB. Each lamp would use a # A86PB pigtail, which is sold separately.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Optronics Trailer Clearance or Side Marker Light - Submersible - Incandescent - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 2-1/2 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Best 7-Way Wiring Harness For 2017 Honda Pilot
- Q&A: Bearing Replacement Recommendation for Timken 07100
- Q&A: Foot Pedal Replacement For A Dometic 310
- Q&A: Looking for Replacement Slam Latch for RV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: What Material Is The Dexter Swing-Away Coupler Made Out Of
- Q&A: Is There a Trailer Wheel with a 5 on 4-1/4 inch Bolt Pattern
- Q&A: When Braking, Trailer Pulls Hard to One Side and Causes Sway
- Article: Trailer Wiring Diagrams
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Raise Your Travel Trailer Height
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: How to Measure a Trailer Axle