Overhead Clearance Necessary to Install Enclosed Trailer Ramp Spring ERS120D81
Updated 05/10/2012 | Published 05/07/2012
Question:
What is the headroom needed to mount the ramp assist above the ramp opening? This is for a Charmac Snowmobile trailer, 2001 model, 27foot long, 9-4inch wide.
asked by: Ralph
0
Expert Reply:
According to our friends at Redneck Trailer Supply, the reel on the end of the Enclosed Trailer Ramp Spring, # ERS120D81 measures 5 inches in diameter, so you would need a bit more than 5 inches of room on the header above the rear door of your snowmobile trailer.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Conventional Ramp Door Spring for 7' Wide Enclosed Trailer - Dual Spring - 120-lb Capacity
- Trailer Ramp Springs
- Dual Ramp Spring
- Torsion Spring
- 150 Inch Cable
- 86 - 120 lbs
- Conventional Spring
- 6 Foot Wide Trailer
- 7 Foot Wide Trailer
- 81 Inch Wide Spring
- M-3 and Associates
more information >
Continue Researching
- Q&A: Choosing/Sizing the Correct Trailer Ramp Spring for a Ramp Door
- Q&A: How to choose the correct conventional ramp door spring
- Q&A: Ramp/Door Spring Recommendation for 2011 Homesteader Enclosed Trailer
- Q&A: Choosing the Correct Replacement Spring for an Enclosed Trailer Ramp Door
- Q&A: Can I Use a Wireless Remote for the MaxxFan Plus part # MA00-04751KSX?
- Q&A: What Size Ramp Door Spring Do I Need for My Trailer?
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Q&A: Weight of Enclosed Trailer Ramp Spring ERS120D81
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: What Does it Mean When an RV is Solar Ready?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation on a Ford Full-Size Van