How To Grease the 8 on 8 Inch Trailer Hub Assembly Part AH60880FCOMP
Updated 10/08/2019 | Published 10/07/2019
Products Featured in This Question
Question:
Is there an alemite/grease fitting installed or a hole tapped to install one?
asked by: Andy
0
Expert Reply:
The Trailer Hub Assembly part # AH60880FCOMP will be lubricated by packing the bearings with wheel bearing grease part # L11380 and a bearing packer part # L70025. That said, there is not any sort of grease fitting on this hub or any trailer hub I am aware of for that matter as this is just not common practice. If a grease fitting is present, it will be located on the end of the spindle but this is only for select axles. The majority of older trailers will be lubricated by hand.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Trailer Hub Assembly - 8 on 8" - 6,000 lb
- Trailer Hubs and Drums
- Idler Hub
- Agricultural
- 506849 / 501349
- Standard Grade
- For 6000 lbs Axles
- 5/8 Inch Stud
- 8 on 8 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- TruRyde
more information >
Continue Researching
- Q&A: Is Easy Grease Trailer Idler Hub Compatible With DeeMaxx Disc Brake Kit
- Q&A: Recommended Air Bags for a 2020 F-250 Tremor
- Q&A: Recommended Disc Brake Conversion Kit for a 2021 Alliance 340RL 5th Wheel Trailer
- Q&A: Replacement Converter for Magnetek 6332 with Inverter and Transfer Switch
- Q&A: Series 6300A Model 6332 Magnetek Replacement Converter
- Q&A: Replacement Hubs for 2000 Dutchman Voyager Pop-Up Camper
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Replacement Seal For National Grease Seal # 5970
- Article: Determining Trailer Tongue Weight