Orientation of Plates When Installing Jensen Antenna # 44US01R
Updated 09/26/2019 | Published 09/25/2019
Question:
Mounting on roof my RV. Where do the plates that come with the antenna go?
asked by: Edward M
1
Helpful Expert Reply:
The rubber plate of the Jensen Antenna # 44US01R goes on the outside of the RV underneath the mounting flange of the antenna and the plastic plate goes on the interior of the RV. The rubber plate acts as a seal and the plastic plate spreads out the torque of the screws so it can be attached tightly without damaging the install location.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Jensen Antenna - Top or Side Mount - Rubber Mast
- RV Antennas
- Radio
- Roof
- Side
- Black
- Jensen
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Scissor Stabilizer Jacks for 2013 Viking Pop Up 1404 GS
- Q&A: Will Skylight # SR89YR Work On 1-1/4" Thick Roof Of 2018 Lance 1575?
- Q&A: Does Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-603-00 Have Ceiling Garnish
- Q&A: Best Brake Controller Option For 2010 Toyota Tundra With Factory Tow package
- Q&A: Looking for Replacement Seals and Races for Hub of 2025 Brinkley Z2900
- Q&A: Are etrailer Scissor Stabilizer Jacks A Compatible Replacement For J-2500 Scissor Stabilizer Jacks
- Q&A: Replacement Stove Top Glass Panels for RV Stove
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: Brake Controller Installation: Starting from Scratch
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Can You Flat Tow a Ford Ranger?
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps