Replacement 7-Way Recommendation for Intertek on Monaco Motorhome

Question

Question:

Hello, I have a 2008 Beaver motor home made by Monaco and it has an Intertec 7 pin plug socket. I’d like to purchase a direct replacement if possible. Do you have one?

asked by: Chuck J

0

Expert Reply:

Thanks for the picture of the 7-way you have on your Motorhome. While we don't carry the Intertek brand the Pollak 7-way part # PK11893 that you referenced is a direct replacement since thankfully the RV industry uses the same design. So this will plug right into the round connector your current 7-way has and work well.

expert reply by: Jameson C

0

Answer 1

In regards to Pollak and Hopkins, they are both great options. That said, if OEM parts give you any indication of quality then Pollak would be the better choice as they are the OEM for most manufacturer in regards to trailer connectors. Personally,…

view full answer...

Answer 2

When the 909508000 part number has come up before it has been in relation to Kwikee 40 Series Steps which use the Replacement Control Unit for Kwikee 40 Series Electric RV Steps #LC363985. Unfortunately your motorhome information doesn't actually…

view full answer...

Answer 3

Since the trailer brake port on your 2021 Jayco built on the Ford E-450 Cutaway does not have any power, causing your Curt Spectrum Trailer Brake Controller #C51170 to not work I recommend double checking that fuse 41 is installed. It is a 30 amp…

view full answer...

Answer 4

Sounds like your brake controller will apply your trailer brakes if you apply the manual override lever but not when you press the brake pedal. This is a fairly common problem and the solution is the red wire of the brake controller. Make sure it is…

view full answer...

Answer 5

Hey Mark, thanks for the pictures. The Curt Dual Connection Socket w/ Bracket item #C36GJ isn't going to fit without some modifications. It will plug directly into your Silverado's OEM USCAR wiring system but you'll have to cut about an…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 8

Hey Troy, welcome back. We haven't had a chance to install the etrailer Invisible Base Plate Kit item #e44FV so the only picture I have is the one from the installation instructions. I have attached it below. Have you gotten yours installed yet?…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Hi Hector; to get that higher speed rating you will need to move up to a 12" tire. The only potential issue is the loss of clearance when compared to your current tires. If you have a 4 on 4 bolt pattern you can use the #AM35351DX and for 5 on…

view full answer...

Answer 11

Wheel offset is very similar to backspacing and refers to the location of a wheel's rim in relation to the wheel's center. Most trailer wheels have a 0 offset, but to determine if the wheels on your trailer have one, you will first want to…

view full answer...

Replacement 7-Way Recommendation for Intertek on Monaco Motorhome

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching